Abstract

BackgroundVanillin is one of the most important aromatic flavour compounds used in the food and cosmetic industries. Natural vanillin is extracted from vanilla beans and is relatively expensive. Moreover, the consumer demand for natural vanillin highly exceeds the amount of vanillin extracted by plant sources. This has led to the investigation of other routes to obtain this flavour such as the biotechnological production from ferulic acid. Studies concerning the use of engineered recombinant Escherichia coli cells as biocatalysts for vanillin production are described in the literature, but yield optimization and biotransformation conditions have not been investigated in details.ResultsEffect of plasmid copy number in metabolic engineering of E. coli for the synthesis of vanillin has been evaluated by the use of genes encoding feruloyl-CoA synthetase and feruloyl hydratase/aldolase from Pseudomonas fluorescens BF13. The higher vanillin production yield was obtained using resting cells of E. coli strain JM109 harbouring a low-copy number vector and a promoter exhibiting a low activity to drive the expression of the catabolic genes. Optimization of the bioconversion of ferulic acid to vanillin was accomplished by a response surface methodology. The experimental conditions that allowed us to obtain high values for response functions were 3.3 mM ferulic acid and 4.5 g/L of biomass, with a yield of 70.6% and specific productivity of 5.9 μmoles/g × min after 3 hours of incubation. The final concentration of vanillin in the medium was increased up to 3.5 mM after a 6-hour incubation by sequential spiking of 1.1 mM ferulic acid. The resting cells could be reused up to four times maintaining the production yield levels over 50%, thus increasing three times the vanillin obtained per gram of biomass.ConclusionFerulic acid can be efficiently converted to vanillin, without accumulation of undesirable vanillin reduction/oxidation products, using E. coli JM109 cells expressing genes from the ferulic acid-degrader Pseudomonas fluorescens BF13. Optimization of culture conditions and bioconversion parameters, together with the reuse of the biomass, leaded to a final production of 2.52 g of vanillin per liter of culture, which is the highest found in the literature for recombinant strains and the highest achieved so far applying such strains under resting cells conditions.

Highlights

  • Vanillin is one of the most important aromatic flavour compounds used in the food and cosmetic industries

  • The experiments (Figure 1, panels A and B) indicated that, when the competitive PCR was performed with a fixed amount of total DNA [2.5 × 107 cell equivalents], equivalent signals for the target and the competitor DNA were obtained with markedly different amounts of competitor: 9.5 × 107 copies (0.075 ng), with DNA from strain JM109(pBB1), and 1.58 × 1010 copies (12.5 ng), with DNA from strain JM109(pFS), respectively

  • Amplification of 16S rDNA fragments yielded bands of the same intensity, confirming that an equivalent number of genomes was present in both DNA samples (Figure 1C). These results indicate that the copy number of pBB1 in JM109 cells is about four copies per genome and that the ferulic catabolic genes were present at 166-fold higher copy number in cells harbouring plasmid pFS

Read more

Summary

Introduction

Vanillin is one of the most important aromatic flavour compounds used in the food and cosmetic industries. The consumer demand for natural vanillin highly exceeds the amount of vanillin extracted by plant sources. This has led to the investigation of other routes to obtain this flavour such as the biotechnological production from ferulic acid. Flavours and fragrances are frequently used in the food, feed, cosmetic, chemical and pharmaceutical industries. Many flavour compounds are produced by chemical synthesis or by extraction from plant and animal sources. Microbial biocatalysis can be used for the production of many flavouring and fragrance aromatic compounds such as vanillin, benzaldehyde, lactones and methylketones [1,3]

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call