Abstract
The main method for calibrating the luminosity at Large Hadron Collider (LHC) is van der Meer scan where the beams are swept transversely across each other. This beautiful method was invented in 1968. Despite the honourable age, it remains the preferable tool at hadron colliders. It delivers the lowest calibration systematics, which still often dominates the overall luminosity uncertainty at LHC experiments. Various details of the method are discussed in the paper. One of the main factors limiting proton–proton van der Meer scan accuracy is the beam–beam electromagnetic interaction. It modifies the shapes of the colliding bunches and biases the measured luminosity. In the first years of operation, four main LHC experiments did not attempt to correct the bias because of its complexity. In 2012 a correction method was proposed and then subsequently used by all experiments. It was based, however, on a simplified linear approximation of the beam–beam force and, therefore, had limited accuracy. In this paper, a new simulation is presented, which takes into account the exact non-linear force. Depending on the beam parameters, the results of the new and old methods differ by sim 1%. This needs to be propagated to all LHC cross-section measurements after 2012. The new simulation is going to be used at LHC in future luminosity calibrations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.