Validation of RELAP5/MOD3.4 for Flashing-Induced Instabilities in a Natural Circulation Loop

Abstract

Abstract This paper aims to validate the effectiveness of the widely used Relap5 code in simulating two-phase natural circulation, and its capability to predict flashing-induced instabilities. The RELAP5 code is validated against experimental data from the NMR test facility, which was designed to investigate the flow instability for a BWR-type novel modular reactor (NMR). The simulations by RELAP5/MOD3.4 code had been performed under various conditions by changing system pressure, core inlet subcooling, core inlet flow resistance, and core heat power etc. The flow stability for a certain operating condition could be determined from the time trace profile of the loop natural circulation flow rate. The results showed that the simulated mass flow rate increased with increasing core inlet temperature, reproducing the experimental trend. And the maximum error between the experimental data and the calculated results is within 10%. The predicted natural circulation dimensionless numbers, the phase change number and inlet subcooling number, also had a good agreement with the experimental data. In general, the RELAP5 code is able to simulate flashing-induced instability and density wave oscillations, which occurred in the natural circulation test facility at low pressures. However, flashing tends to be suppressed at a higher pressure (400kPa). And the enlargement of core inlet resistance coefficient can also have a positive impact on natural circulation system stability.