Abstract
Soil moisture-monitoring equipment is difficult to install in poorly consolidated sand or sediments using hand tools because the loose material tends to collapse. The technique described herein uses a 5.5-hp wet/dry vacuum cleaner, powered by a portable gasoline generator, to remove the soil while an operator pushes a conductor pipe or casing into the profile. After initiating the hole using a hand bucket auger, an open-ended metal pipe or polyvinyl chloride (PVC) casing is inserted vertically into the shallow hole. A smaller tube, or stinger, attached to a wet/dry vacuum is inserted into the pipe to extract loose material while downward pressure is applied on the pipe. Once the casing is installed, instrumentation such as lysimeters, gypsum blocks, or tensiometers can be placed at the desired depth and backfilled with native soil. The casing is then raised and the soil allowed to collapse around the equipment, or the pipe can be left in place for neutron probe access. Measurements of soil water content after an infiltration experiment demonstrated uniform downward movement with minimal preferential flow or soil disturbance as a result of the vacuum installation of gypsum blocks and a neutron access tube.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
