Vacuum insulated glazing (VIG) units under wind load—part 1: global deformation and stresses on the outer glass surfaces

Abstract

This paper presents the first part of a study on the effect of wind loads on Vacuum Insulated Glass (VIG) units. The study provides background information on VIG and relevant Standards, explains the numerical modelling process, and discusses the implications of the results in relation to European and North American codes and Standards. The focus of the study is on vertical windows and façade installations in low-rise buildings (< 25 m) commonly found in residential buildings. The mechanical behaviour of VIG was analysed using the Finite Element Method (FEM) with respect to various design parameters such as glass pane size, glass thickness, surface pressure magnitude, and edge boundary conditions. The study analysed global deformation as well as the stresses on the outer glass surfaces. The VIG features such as pillar geometry and contact dynamics, and material non-linear effects, were explicitly modelled. In addition, monolithic glass plates were also modelled, and the FEM results of the monolithic cases were in reasonable agreement with an analytical solution obtained from linear thin plate theory. These results highlight the limit of linear behaviour in monolithic plate bending. The centre-of-pane deflection of the VIG was in good agreement with the FEM and analytical solutions of the equivalent thickness monolithic pane, for sample sizes below 800 × 800 mm. However, for larger glass sizes, a deviation was found, and the VIG exhibited a higher plate stiffness than the equivalent thickness monolithic pane. The simulations also showed that the stresses in the glass panes are highly dependent on the edge of glass boundary condition. Finally, the results demonstrated that with appropriate design choices, the VIG can satisfy the Standards requirements for wind load and glass design in both Europe and North America.