Vacuum electrical breakdown characteristics and surface condition of ti electrodes with oxidation conditions

Abstract

Outgassing from an electrode surface is regarded as a major factor leading to electrical breakdowns in vacuum. Recently oxidation treatment at 200/spl deg/C was reported as an effective means of reducing Ti outgassing. In this paper, we report our measurement and comparison of the electrical breakdown characteristics of Ti electrodes with different oxidation conditions (without oxidation, oxidation at 200/spl deg/C, oxidation at 450/spl deg/C). In addition, we analyzed electrode surfaces before and after breakdown experiments in situ with X-ray photoelectron spectroscopy (XPS). Before oxidation, we machined the electrode's surfaces to the roughness of 0.8 /spl mu/m Rmax with diamond turning. Breakdown experiments demonstrated that the breakdown field is highest at the first application of voltage to electrodes with oxidized at 200/spl deg/C. Before breakdown experiment, surface analysis revealed that all the sample electrodes had a large amount of carbon originating from the hydrocarbons of contaminants, and after the experiments, they revealed that the carbons had disappeared. To obtain breakdown characteristics of electrodes with smoother surfaces, we conducted experiments on electrodes with a surface roughness of 0.05 /spl mu/m Ra. For these electrodes, the breakdown field was higher at first breakdown; the repetitions required to achieve saturated breakdown fields were significantly fewer, and the amount of carbon on electrode surfaces before breakdown was less.