Abstract
We present experimental results of fluctuation-enhanced gas sensing by low-cost resistive sensors made of a mixture of graphene flakes and TiO2 nanoparticles. Both components are photocatalytic and activated by UV light. Two UV LEDs of different wavelengths (362 and 394 nm) were applied to modulate the gas sensing of the layers. Resistance noise was recorded at low frequencies, between 8 Hz and 10 kHz. The sensors’ response was observed in an ambient atmosphere of synthetic air and toxic NO2 at selected concentrations (5, 10, and 15 ppm). We observed that flicker noise changed its frequency dependence at different UV light wavelengths, thereby providing additional information about the ambient atmosphere. The power spectral density changed by a few times as a result of UV light irradiation. The sensors were operated at 60 and 120°C, and the effect of UV light on gas sensing was most apparent at low operating temperature. We conclude that UV light activates the gas-sensing layer and improves gas detection at low concentrations of NO2. This result is desirable for the detection of the components of gas mixtures, and the modulated sensor can replace an array of independent resistive sensors which would consume much more energy for heating. We also suggest that a more advanced technology for preparing the gas-sensing layer, by use of spin coating, will produce corresponding layers with thickness of about a few μm, which is about ten times less than that for the tested samples. The effects induced by the applied UV light, having a penetration depth of only a few μm, would then be amplified.
Highlights
Resistive gas sensors are of much current interest because of their low-cost production and simple applications to detect a range of gases [1, 2]
We presented experimental results of NO2 sensing by lowcost gas-sensing layers made from graphene flakes/TiO2 nanoparticles mixtures
The layers were modulated by UV light irradiation using two LEDs with different emitted wavelengths
Summary
Resistive gas sensors are of much current interest because of their low-cost production and simple applications to detect a range of gases [1, 2]. The sensors are activated for gas detection at elevated temperature, and the operating temperature determines the selectivity and sensitivity of the MOS sensors. Nanoparticles, typically of noble metals such as Au and Pt, can dope the sensors and induce catalytic effects so as to further improve selectivity and sensitivity [3]. One can improve gas detection by applying an array of MOS gas sensors with selectivity optimized for chosen gases, but this solution leads to additional costs of preparing the set of gas sensors and their operation during practical use. Novel gas-sensing methods are desired for enhancing gas detection by low-cost MOS sensors and need to be applied beyond measuring the sensors’ DC resistance
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
