Abstract
A new high-barrier coating based on methyl (α-hydroxymethyl)acrylate (MHMA) for poly(ethylene terephthalate) (PET) was developed along with the process for preform dipping and cure prior to blow molding into bottles. The UV curable coating gives excellent gas barrier improvement when coated onto PET biaxially oriented thin films. Blown bottle side walls from coated PET preforms also show 2–3 times improvement over uncoated side walls. The effect of photoinitiator concentration, initiator types, and temperature on photopolymerization kinetics of MHMA was investigated. Once the photoinitiator, Irgacure 819®, concentration became larger than 1mol%, a decrease in rate of propagation was observed. The conversion also decreased with higher initiator concentration. Irgacure 819® reduced the auto-acceleration peak and reached maximum rates of polymerization much faster than Irgacure 651®. It also gave a slightly higher conversion. Overall conversion for combinations of these photoinitiators was high, above 80%. Real-time FTIR (RT-FTIR) studies of copolymerization of MHMA and methyl methacrylate (MMA) showed that conversion was fairly high up to 25mol% MMA. However, once MMA feed ratio exceeded 10mol%, a decrease in barrier performance was observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
