UV/Advanced Oxidation Process for Removing Humic Acid from Natural Water: Comparison of Different Methods and Effect of External Factors

Abstract

Humic acid (HA) is an organic compound naturally present in aquatic environments. It has been found to have detrimental effects on water color, the transport of heavy metals, and the elimination of disinfection by-products (DBPs), thereby exerting an impact on human health. This study introduced four synergistic ultraviolet/advanced oxidation processes (UV/AOPs) systems aimed at eliminating HA from water. The research explored the effect of solution pH, duration of illumination, initial reactant concentration, and oxidant concentration on the degradation of HA. The results indicated that the mineralization rate achieved by individual UV or oxidant systems was less than 15%, which is significantly lower compared to UV/AOPs systems. Among these methods, the UV/peroxymonosulfate (UV/PMS) process demonstrated the highest effectiveness, achieving a mineralization rate of 94.15%. UV/peroxydisulfate (UV/PDS) and UV/sodium percarbonate (SPC) were subsequently implemented, with UV/sulfite (S(IV)) demonstrating the lowest effectiveness at 19.8%. Optimal degradation efficiency was achieved when the initial concentration of HA was 10 mg/L, the concentration of PMS was 3 mmol/L, and the initial pH was set at 5, with an illumination time of 180 min. This experimental setup resulted in high degradation efficiencies for chemical oxygen demand (COD), UV254, and HA, reaching 96.32%, 97.34%, and 92.09%, respectively. The energy efficiency of this process (EE/O) was measured at 0.0149 (kWh)/m3, indicating the capability of the UV/PMS system to efficiently degrade and mineralize HA in water. This offers theoretical guidance for the engineered implementation of a UV/PAM process in the treatment of HA.