Utilizing artificial intelligence to determine bone mineral density using spectral CT

Abstract

BackgroundDual-energy computed tomography (DECT) has demonstrated the feasibility of using HAP-water to respond to BMD changes without requiring dedicated software or calibration. Artificial intelligence (AI) has been utilized for diagnosising osteoporosis in routine CT scans but has rarely been used in DECT. This study investigated the diagnostic performance of an AI system for osteoporosis screening using DECT images with reference quantitative CT (QCT). MethodsThis prospective study included 120 patients who underwent DECT and QCT scans from August to December 2023. Two convolutional neural networks, 3D RetinaNet and U-Net, were employed for automated vertebral body segmentation. The accuracy of the bone mineral density (BMD) measurement was assessed with relative measurement error (RME%). Linear regression and Bland–Altman analyses were performed to compare the BMD values between the AI and manual systems with those of the QCT. The diagnostic performance of the AI and manual systems for osteoporosis and low BMD was evaluated using receiver operating characteristic curve analysis. ResultsThe overall mean RME% for the AI and manual systems were − 15.93 ± 12.05 % and − 25.47 ± 14.83 %, respectively. BMD measurements using the AI system achieved greater agreement with the QCT results than those using the manual system (R2 = 0.973, 0.948, p < 0.001; mean errors, 23.27, 35.71 mg/cm3; 95 % LoA, −9.72 to 56.26, −11.45 to 82.87 mg/cm3). The areas under the curve for the AI and manual systems were 0.979 and 0.933 for detecting osteoporosis and 0.980 and 0.991 for low BMD. ConclusionThis AI system could achieve relatively high accuracy for automated BMD measurement on DECT scans, providing great potential for the follow-up of BMD in osteoporosis screening.