Utilization of the Planar Laser-Induced Fluorescence Technique (PLIF) to Measure Temperature Fields in a Gas-Stirred Ladle

Abstract

A 1/17th water physical model of a 200-ton steel ladle furnace with a single gas injection was used to simulate bath heating using a single burner to mimic the heat flux due to electric arcs in the industrial steel ladle. Two phases were considered, using water to simulate the molten steel and air to simulate the argon injection at a flow rate of 1.54 NL min−1. The planar Laser-Induced Fluorescence (PLIF) technique was for the first time experimentally implemented to measure temperature fields in a longitudinal plane of the gas-stirred ladle model. PLIF employs a laser source of 532-nm wavelength to light water seeded with rhodamine B, which emits fluorescence depending on its temperature, after a complex calibration is made. Next, the fluorescence is captured by a camera with a 550-nm wavelength filter. The PLIF measurements were validated by local thermocouple measurements at five different locations in the measurement plane. Temperature fields measured by PLIF are in good agreement with those obtained locally by thermocouples, so the PLIF technique can be used to measure temperature fields with the advantage of getting a complete temperature contour field, in contrast to point values of temperatures with thermocouples. Experiments were carried out to study the thermal mixing for two common tuyere positions, i.e., axisymmetric and eccentric (mid-radius) positions. Results on the injection mode show that axisymmetric gas injection is a more efficient heat transfer configuration between the burner and the liquid phase than is the symmetric injection mode for the particular heating configuration studied in this work.