Utilization of coffee by-products for the production of alcoholic and non-alcoholic beverages and their physiochemical and sensory characteristics

Abstract

Coffee pulp is the first byproduct of coffee processing. It contains contaminants due to its composition and production volume. This study evaluates coffee by-products wine from fresh coffee pulp, used as a substrate, along with cascara tea from dried coffee pulp. About 40 % of pulp was obtained during the wet processing of coffee. The pulp was dried directly in the sun for 3–4 days until the moisture content of the cascara drink was below 8 %. Similarly, for the alcoholic beverage (wine), the must was processed to the TSS (24°Brix), and the fermentation process was carried out for up to 10–12 days until the TSS was down to 10°Brix. After the fermentation was completed, the fermented wine was kept for secondary fermentation where it undergoes aging or clarification. The clarified wine was then filled into sterilized glass bottles for further use. The chemical composition of coffee pulp (moisture, ash, crude protein, acidity, fat, crude fiber, caffeine, tannin, reducing sugar, TSS, and flavonoids) was analyzed. Both beverages were also subjected to sensory analysis and chemical analysis Caffeine, tannin, pH, and acidity of the non-alcoholic beverage were 220 mg/L, 45.7 mg/L, 4.16 and 1.24 %, respectively. Alcohol, methanol, ester, aldehyde, pH, TSS, acidity, caffeine, tannin, and flavonoid were 10.58 ABV %, 295 mg/L, 75.26 ppm, 10.12 ppm, 3.2, 10°Brix, 0.52 %, 28.96 ppm, 280 mg/L and 405 mg/g, respectively. The alcoholic and non-alcoholic beverages made from coffee pulp were superior in terms of sensory attributes. Therefore, it is possible to develop both beverages from coffee pulp and maximum utilization of waste coffee pulp