Abstract
In this paper, we change terminal loads of a microstrip line to separate electric field coupling and magnetic field coupling between a microstrip line and a transverse electromagnetic (TEM) cell during radiated emission measurement. Such separation can also be validated by another terminal load. After validation, the effect of termination on both couplings is investigated, and the requirements of termination impedance to suppress the two couplings are revealed. In addition, we find that the linear physical models deriving both lumped coupling parameters only hold below a limited frequency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Electromagnetic Compatibility
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
