Using supercritical carbon dioxide as solvent to replace water in polyethylene terephthalate (PET) fabric dyeing procedures

Abstract

Dyeing fabrics in supercritical carbon dioxide (SCD) instead of water can save energy, reduce water use and prevent pollution. The special pilot plant was designed to test dyeing procedures in supercritical carbon dioxide and the analyses of the results indicate major benefits as compared to water based procedures. The dyeing of polyethylene terephthalate (PET) fabric in supercritical carbon dioxide using special pilot plant was investigated. Disperse dye, C.I. (color index) Disperse Blue 79, was used in this study. After dyeing, rinsing in supercritical carbon dioxide, which removes the excess dyes, was also discussed. At the same dyeing conditions, K/ S (color yield) of dyed fabric significantly increased with increasing the dye concentration from 1% o.w.f. (on weight of fabric) to 5% o.w.f. Dyeing temperature and pressure had a strong influence on the color yield. When the temperature rose above 110 °C, the increase in color yield was obvious. At 20 MPa, 120–130 °C, dyeing reached equilibrium after 60 min. The excess dye of the dyed PET fabric was small. The suitable condition in supercritical carbon dioxide for removal of excess dye from the dyed fabric was 70 °C, 20 MPa. The PET fabric dyed in supercritical carbon dioxide had good fastness and physical properties.