Abstract
Many kinds of processes have been used to make flexible LCDs. In this paper, we fabricate a flexible LC device by replica molding method – using Poly(dimethylsiloxane) (PDMS) rather than plastic to be the substrate. The PDMS can not only act as the substrate but also the alignment-layer in flexible LCDs; thus there is no need to coat additional alignment-layer on the flexible substrates. One significant achievement of our method is to increase the flexibility of rollable LC devices. The other one is to decrease the processing steps compared with those in other conventional processes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
