Using relative permeability curves to evaluate phase trapping damage caused by water- and oil-based drilling fluids in tight-gas reservoirs

Abstract

Low matrix permeability and significant damage mechanisms are the main signatures of tight-gas reservoirs. During the drilling and fracturing of tight formations, the wellbore liquid invades the tight formation, increases liquid saturation around the wellbore, and eventually reduces permeability at the near wellbore zone. The liquid invasion damage is mainly controlled by capillary pressure and relative permeability curves. Due to high critical water saturation, relative permeability effects and strong capillary pressure, tight formations are sensitive to water invasion damage, making water blocking and phase trapping damage two of the main concerns with using a water-based drilling fluid in tight-gas reservoirs.Therefore, the use of an oil-based mud may be preferred in the drilling or fracturing of a tight formation. Invasion of an oil filtrate into tight formations, however, may result in the introduction of an immiscible liquid-hydrocarbon drilling or completion fluid around the wellbore, causing the entrapment of an additional third phase in the porous media that would exacerbate formation damage effects. This study focuses on phase trapping damage caused by liquid invasion using a water-based drilling fluid in comparison with the use of an oil-based drilling fluid in water-sensitive, tight-gas sand reservoirs. Reservoir simulation approach is used to study the effect of relative permeability curves on phase trap damage, and the results of laboratory experiments of core flooding tests in a West Australian tight-gas reservoir are shown, where the effect of water injection and oil injection on the damage of core permeability are studied. The results highlight the benefits of using oil-based fluids in drilling and fracturing of tight-gas reservoirs in terms of reducing skin factor and improving well productivity.