Abstract

The use of photogrammetry provides an inexpensive, alternative method that can simplify the processes traditionally carried out in the orthotics workshop. The objectives of this study are to develop a method based on photogrammetry to obtain 3D-printed positive foot casts for fabricating thermoconformed orthoses from a negative cast in phenolic foam. Using a basic Smartphone, a photo capture protocol for feet, free software and a 3D printer, we tested the suitability of the positive cast obtained to fabricate custom foot orthoses using thermoconformed 3 mm polypropylene in the orthotics laboratory. The results show that digitally fabricated casts provide a very close replicate of the positive casts obtained traditionally through plaster casting (maximum dimension discrepancy between casts of 2 mm in length and 0.4 mm in forefoot, midfoot and rearfoot measurements). They are also suitable for the process of fabricating 2- and 3-mm polypropylene thermoconformed plantar orthoses. Photogrammetry can be used as a new method to obtain a positive 3D foot cast suitable for fabricating custom orthoses, in a valid, safe, cleaner and more lasting procedure that removes the process of plaster casting.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.