Using orthogonal pairs of rollers on concave beds (OPRCB) as a base isolation system—part II: application to multi‐story and tall buildings

Abstract

Listen

Translate article

SUMMARYApplication of orthogonal pairs of rollers on concave beds (OPRCB) isolating system to short‐ and mid‐rise buildings is presented in this paper. At first, the analytical formulation of the set of equations, governing the motion of Multi Degree of Freedom (MDOF) systems, isolated by OPRCB isolators, has been developed. Then, some multi‐story regular buildings of shear type have been considered, once on fixed bases and once installed on the OPRCB isolators. Next, some horizontal and vertical accelerograms of both far‐ and near‐fault earthquakes with low‐ to high‐frequency content, particularly those with remarkable peak ground displacement values, have been selected and normalized to three peak ground acceleration levels of 0.15 g, 0.35 g and 0.7 g, and their stronger horizontal component simultaneous with their vertical component have been used for response analysis of the considered buildings. Story drifts and absolute acceleration response histories of isolated buildings have been calculated by using a program, developed in MATLAB environment by using the fourth‐order Runge–Kutta method, considering the geometrically nonlinear behavior of isolators. Maximum relative displacement and story drifts as well as absolute acceleration responses of considered isolated buildings for various earthquakes have been compared with those of corresponding fixed‐base buildings to show the high efficiency of using OPRCB isolators in multi‐story and tall regular buildings. Copyright © 2010 John Wiley & Sons, Ltd.