Using inverse theory and seabeam bathymetry to improve seismic refraction data corrections

Abstract

An array consisting of ocean bottom seismometer and on-bottom hydrophones, was used to conduct a seismic experiment on 0.4 Ma crust east of the Juan de Fuca Ridge. Seismic sources were large (>50 kg) explosive charges detonated by SUS devices set to explode at 1829 or 2438 m nominal depth. The objectives of the experiment were to determine the compressional wave velocity and attenuation structures of the uppermost 500 m depth. The relative positions of shots and receivers were originally determined by treating each shot-receiver pair independently, via raytracing of various water waves. Due to the reflection of some of these water waves by the rough bottom, significant scatter resulted, preventing a determination of a physically realizable velocity-depth function. A new method is described that co-locates shot and receiver positions, including receiver depths consistent withseabeam bathymetry, using only the water waves that do not interact with the bottom. Several potential pitfalls are outlined using this method. A stable solution could only be achieved by discarding shots located well outside the array. The water path corrections were applied to the refracted arrivals, again using theseabeam bathymetry. The joint inversion location procedure, along with the use of precise gridded bathymetry, reduced the travel time scatter to a level whereby a velocity-depth function could be determined. The results, using only the hydrophone data, indicate an initial velocity at the seafloor of 2.7 km s-1 with gradients from 4.6 s-1 slowly decreasing to 4.1 s-1 at 679 m depth. This velocity is similar to others conducted over very young oceanic crust, and can be interpreted as being due to a high porosity at the surface, due to cracks, fissures, and open pores, which rapidly diminish with depth.