Using Confocal Microscopy and Digital Image Correlation to Measure Local Strains Around a Chip Corner and a Crack Front

Abstract

In a flip chip package, the chip corner areas which are embedded in the underfill material are often critical to the damage initiation, since a stress concentration usually exists at these locations. A high level of stress concentration often promotes crack initiation from the chip corner. In order to better understand the local deformation around chip corners and crack tips, a method based on laser scanning confocal microscopy combined with the digital image correlation (confocal-DIC) was developed to measure local strain directly in deformed, transparent objects. A transparent epoxy resin with alumina particle fillers was used in four different types of samples, which were fabricated for the purpose of validation. A non-constrained sample and a thin-layer sample were used to verify the isotropic thermal expansion and the strain gradients with respect to the depth, respectively. Results from both samples were in good agreements with the calculation from the coefficient of thermal expansion (CTE) and FEM simulations. Furthermore, the confocal-DIC technique was applied to measure the strain distribution near the chip corner area of a third sample replicating the geometry of a flip chip package. The measured maximum first principal strain was located at the chip corner, reaching 0.9% at 60 °C, in a good agreement with the simulation results. The strain in front of the crack tip was also evaluated by a three-point bending test in a fourth test sample. The measured maximum strain was 5.8± 0.7%, corresponding to a relative error of only about 5% compared to simulations for a round crack tip configuration. The averaging used in DIC lowers its spatial resolution and makes it difficult to capture higher strain gradients in small regions. However, the confocal-DIC approach appears to be able to provide reasonable results for evaluating the maximum strain and the full field strain distribution in tri-dimensional volumes with geometries, materials and dimensions which are very similar to those of actual flip chip microelectronic packages.