Abstract
Surge protective devices (SPDs) are used in protecting low voltage distribution networks against lightning strike. Lightning strike not only produces overvoltage but also comes with discharge current. Even if the voltage is clamped by the SPD, the discharge current from the lightning strike may cause SPD to fail. Normally, people look at clamping voltage (voltage protection level) without looking properly at the maximum allowable energy of SPD. This paper looks in the SPDs failure on the low voltage installation which been served by overhead lines. In this paper, the work is done in order to calculate the probability of SPDs failure based on the actual lightning data in Malaysia. The peak current is a probability phenomenon. By looking at the probability of lightning peak current and location of those lightning activities, it is possible to calculate the kind of induced voltage to appear on the electrical installation. From the calculated results, a better selection of SPD size to be installed can be assured.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
