Use of silane-functionalized graphene oxide in organic photovoltaic cells and organic light-emitting diodes.

Abstract

Graphene oxide (GO) and silane-functionalized GO (sGO) sheets obtained through a simple sonication exfoliation method are employed as hole transport layers to improve the efficiency of organic photovoltaic (OPV) cells and organic light-emitting diodes (OLED). GO was functionalized using (3-glycidyl oxypropyl)trimethoxysilane (GPTMS) and triethoxymethylsilane (MTES). The appearance of new peaks in the Fourier-transform infrared spectra of the sGOs indicates the formation of Si-O-C, Si-O-Si, Si-H, and Si-O-C moieties, which provide evidence of the addition of silane to the GO surface. Furthermore, the appearance of Si-O-Si bonds in the synchrotron radiation photoelectron spectra (SRPES) of the MTES-sGO and GPTMS-sGO samples suggests that silane groups were effectively functionalized onto the GO sheets. An OPV cell with GO layers showed a lower performance with a power conversion efficiency (PCE) of 2.06%; in contrast, OPV cells based on GPTMS-sGO and MTES-sGO have PCE values of 3.00 and 3.08%, respectively. The OLED devices based on GPTMS-sGO and MTES-sGO showed a higher maximum luminance efficiency of 13.91 and 12.77 cd A(-1), respectively, than PEDOT:PSS-based devices (12.34 cd A(-1)). The SRPES results revealed that the work functions of GO, GPTMS-sGO, and MTES-sGO were 4.8, 4.9, and 5.0 eV, respectively. Therefore, the increase in the PCE value is attributed to improved band-gap alignment. It is thought that sGO could be used as an interfacial layer in OPV and OLED devices.