Abstract
Summary The determination of optimal well settings is very demanding computationally because the simulation model must be run many times during the course of the optimization. For this reason, reduced-order modeling procedures, which are a family of techniques that enable highly efficient simulations, may be very useful for optimization problems. In this paper, we describe a recently developed reduced-order modeling (ROM) technique that has been used in other application areas, the trajectory piecewise linearization (TPWL) procedure, and incorporate it in production-optimization computations. The TPWL methodology represents solutions encountered during the optimization runs in terms of Taylor-series expansions around previously simulated states. This requires a small number of preprocessing (training) simulations using the full (high-fidelity) model, during which pressure and saturation states and Jacobian matrices are saved. These states and matrices are then projected into a low-dimensional space using proper orthogonal decomposition (POD). Simulations in this reduced space can be performed very efficiently; in this work, we observe runtime speedups of a factor of 450. Overall speedups are, however, less because of the preprocessing overhead. We assess the TPWL representation for simulations of waterflood in a heterogeneous 3D model containing more than 20,000 gridblocks and six wells. The high degree of accuracy of the TPWL model is first demonstrated for several testing simulations in which producer- and injector-well settings differ from those used in the training runs. The TPWL representations are then used in optimizations involving the determination of optimal bottomhole pressures (BHPs) for a reservoir model with four production wells and two injection wells. A gradient-based algorithm is applied for the optimizations. In the first case, the BHPs of the producers and injectors are optimized at six different times (36 control variables) and in the second case at 15 different times (90 control variables). Results for optimized net present value (NPV) using TPWL are shown to be in consistently close agreement with those computed using high-fidelity simulations. Most significantly, when the optimal well settings obtained using the TPWL procedure are applied in high-fidelity models, the resulting NPVs are within approximately 0.5% of the values determined using the high-fidelity simulations. Our overall conclusion is that the TPWL representation may be quite useful in production-optimization problems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.