Use of automated geodetic devices when assembling technological equipment

Abstract

The article considers the method of determining the geometric parameters of technological equipment with the use of automated total stations. It analyses the results of production work to determine the spatial position of the equipment. It is noted that under certain conditions, the use of total stations allows determining the spatial position of control points on the equipment with the necessary accuracy. The preliminary investigations of accuracy by all modes of measurements distances and angles in the laboratory conditions and conditions, as close as possible to real are recommended. To perform measurements at short distances, an improved measurement technique is proposed. The peculiarity of the proposed technique is that during measurements it is proposed to use simultaneously a high-precision automated total station and a high-precision digital level. The article gives the results of measurements. It is established that the considered technique makes it possible to increase the accuracy of determining the control points’ marks on the equipment.