Use of 3-D Printed Models for Implant Placement - A Case Series

Abstract

Long-term stability of a dental implant depends on various factors, one among them is proper position within the alveolar bone. Pre-operative thorough examination of the surgical site is preliminary step while planning dental implants. Conventional techniques such as Intra-Oral Periapical Radiograph and Ortho Pantamogram sometimes not sufficient and clinical scenario always surprises the surgeon. Later advent of Cone-Beam Computed Tomography alleviated this problem to some extent but there are some clinical situations such as resorbed ridge where better visualisation is needed. This led to the innovation of rapid prototyping techniques for the fabrication of three-dimensional complex structures. This technology has numerous applications from the development of an instrument, 3-D printed anatomical models to the fabrication of 3-D printed tissues for regeneration procedures. A 3-D printed model is much more useful than plaster models in many aspects such as demonstrating anatomical structures, better treatment planning, and better understanding for the patient. Hence, this case series focuses on the use of 3-D printed models in the placement of dental implants.