Abstract

In order to determine uranium from raw phosphoric acid solutions, resulted by the sulphuric acid attack of phosphate rocks and the strip solutions of the solvent extraction process for uranium recovery, two classes of analytical methods were established: one for low uranium content in phosphoric acid, and the other for higher uranium concentration in the same medium. The study was based on specific methods, therefore interference probability with other impurities in phosphoric acid medium is low. In the first class, X-ray fluorescence and spectrophotocolorimetric methods were used. X-ray fluorescence was applied on direct raw phosphoric acid solution and raffinate. The last one was associated with solvent extraction [di-(2-ethylhexyl) phosphate + triocylphosphine oxide] on the U(IV)-Arsenazo III complex in strip. The methods of the second class, were used for strip uranium concentrated solutions: X-ray fluorescence isotopic dilution and mass spectrometry, spectrophotocolorimetry and activation analysis associated with gamma-spectrometry. Here spectrophotocolorimetry involves two methods. The first one is based on the U(IV)-Arsenazo III complex and the other on direct U(IV)—phosphoric acid solutions measurements. A good agreement was obtained in each case for all comparative measurements involving various methods.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.