Abstract
Helical piles have been widely used in Brazil to resist uplift forces of transmission line towers due to certain advantages compared with other foundations, such as resistance to both compressive and tensile loads, easy transport to remote sites, possibility of installation at batter angles, rapid installation with small equipment, and no need for concrete and formwork. However, in some sites the appropriate soil layer for the installation of the pile helices is too deep or too hard to be penetrated. In these cases, the use of helical foundations is not economically and (or) technically viable. One possible solution for this problem is to install the pile in a soil with low bearing capacity improved with cement injection. To evaluate the applicability of a soil-treatment method for helical piles, two different procedures of injection were tested in typical Brazilian residual soils of different geologic origin. For this investigation, 41 multi-helix piles (15 conventional piles and 26 with cement injection) were installed and submitted to tensile loading tests. The results reveal that both techniques can improve the tension capacity and produce a stiffer load–displacement response of helical piles under uplift loads.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
