Abstract
UOE pipe manufacturing processes influence directly on pipeline resilience and operation capacity. At present, most spread pipe manufacturing method is UOE. This kind of manufacturing process is based on cold forming principle. To avoid appearance of unwanted effects, the need to know the level of strains resulted after every technological step appeared. For this case a manufacturing process by using special designed equipment is simulated. The experimental simulation presented in this paper is performed for L 415MB (X60) steel plate with 7.9 mm thickness and a width of 1250 mm. As a result a DN 400 (16 inch) pipe is obtained. Manufacturing process is monitored by Digital 3D Image Correlation System Q-400 and the principle of operation is based on Digital Image Correlation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
