Abstract
The study presented in this work focuses on the preparation of composites made of multi-walled carbon nanotubes (MWCNTs) and magnesium aluminate spinel through a pressureless sintering technique. The effects of sintering temperature and MWCNTs content on the densification behavior and mechanical properties of the composite were investigated in detail. The results revealed that the composite exhibited improved densification behavior, enhanced mechanical performance and decent control at the microstructural refinement with increasing MWCNTs content up to 0.75 wt%. The superior mechanical properties obtained in case of sintered composite were attributed to the synergetic toughening mechanisms involving the fiber pull out, cracks bridging and cracks deflection effects of reinforcing phases, observed as a resultant effect of strong interfaces with the matrix phase. The crystalline structural arrangement obtained from the XRD and Raman spectral analysis of the composites structure also satisfies the attainment of the promising reinforcement potential of the nanotubular structure. Most importantly, the study also exemplified the subsidiary interference of a surface decorative coating on the MWCNTs structure with the MgAl-binary oxide network. The strategic grafting of the oxide protective shell and the consequent development of a robust interfacial bridging network between the matrix and reinforcement phase regulated the energy dissipation characteristic for fiber debonding. This, in turn, restricted the crack growth phenomenon during mechanical loading, and thereby ultimately contributing to the enhanced fracture toughness, reduced thermal expansion co-efficient and augmented thermo-mechanical performance of the evolved spinel-based composite structure
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.