Unveiling the potential of TPA-based molecules to tune the optoelectronic properties and enhance the efficiency of dye-sensitized solar cells.

Abstract

The world's energy and environmental requirements are changing due to rapid population growth and industrial growth, and solar cells can be used to meet these demands. Dye-sensitized solar cells (DSSCs) are solar cells in which energy conversion occurs via a process similar to photosynthesis in plants. DSSC development is still in its infancy. DSSCs can operate under cloudy conditions and indirect sunlight and have attracted considerable attention due to their low cost and high efficiency. We designed two metal-free TPA-based dyes (Dye2 and Dye3) based on the reference dye Mg207 (Dye1) by increasing the donor strength of the molecule, as such dyes have shown enhanced efficiency in DSSCs. Moreover, the triphenylamine (TPA) moiety has been demonstrated to be a good donor that prevents charge recombination. Intramolecular charge transfer (ICT) from the donor to acceptor moiety was found in the sensitizers, and electrons were promoted to the conduction band (CB) of the TiO2 semiconductor. The negative binding energy of the dye@TiO2 clusters indicated that dye adsorption on the semiconductor surface was stable. The double donor increased the electron injection and electronic coupling constants in Dye2 and Dye3, indicating that these newly designed dyes have superior charge injection capacity. Accordingly, the efficiencies of DSSCs with Dye2 and Dye3 were 9.77% and 9.62%, respectively, and substitution with the TPA unit at the -R1 and -R2 positions in Dye1 resulted in better power conversion compared to the parent compound (9.09%). Increased donor strength improved photovoltaic performance by increasing current density and light-harvesting efficiency. This is a good molecular design approach for preparing targeted donor- -acceptor (D- -A) organic dyes with high DSSC efficiency. To predict the charge transport and optoelectronic characteristics of the TPA dyes, quantum chemical calculations were carried out using Gaussian16. The ground-state (S0) optimized geometries of the sensitizers were computed by utilizing DFT at the B3LYP/6-31G** level. The absorption spectra ( max) were computed by employing TD-DFT with various functionals (B3LYP, PBE1PBE, CAM-B3LYP, and BHandHLYP) in the gas and solvent (DCM) phases. Among the studied functionals, BHandHLYP was found to be best at successfully reproducing the experimental data. Thus, the absorption spectra of the newly designed dyes and dye@TiO2 were calculated at the BHandHLYP/6-31G** level. The dye@TiO2 cluster optimizations were carried out at the B3LYP/6-31G**(LANL2DZ) level.