Abstract
AbstractDialkyl carbonates (DACs) own an environmentally friendly synthesis route, making them potential candidates as alternative fuels. However, for DACs to be widely accepted as an alternative fuel, a comprehensive understanding of their combustion behavior is essential. Dipropyl carbonate (DPrC) represents a transition from short‐chain to mid‐chain carbonates, understanding its combustion behaviors holds significance in unraveling the combustion chemistry of carbonates. In this study, the oxidation of DPrC was investigated with the initial fuel mole fraction of 0.5% at three equivalence ratios of 0.5, 1.0, and 2.0 within a temperature range of 550–1100 K in a jet‐stirred reactor for the first time. Gas chromatography was utilized for the quantitative detection of reactants, intermediates, and products. A detailed DPrC mechanism was first developed, and good agreements between measurements and simulations were obtained. A notable negative temperature coefficient (NTC) behavior was first observed in the oxidation of DACs. Such NTC phenomenon occurred at fuel‐lean conditions in the temperature range of 620–660 K, while only a weak low‐temperature consumption was observed at the stoichiometric condition. Kinetic modeling studies showed that this unique low‐temperature chemistry of DPrC can be attributed to the differences in the RO2 isomerization reactions between DPrC and short‐chain DACs. The RO2 isomerization via a six‐member ring transition state could happen in DPrC oxidation but not in dimethyl carbonate and diethyl carbonate oxidation, due to the different fuel molecular structure. Therefore, the subsequent reaction pathways via QOOH → O2QOOH → HO2Q = O + OH → OQ = O + OH were promoted and two OH radicals were released in this process. Moreover, it is conceivable that mid or long‐chain DACs could also exhibit an NTC phenomenon due to the increased potential for RO2 isomerization via a six‐ or seven‐member ring transition state, thereby increasing the likelihood of RO2 isomerization occurrence.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.