Abstract
In the wafer sawing process, unusual failures were observed and their root causes have been investigated. Besides classical and well-known failures, the following failure mechanisms were found. Surface-ESD (ESDFOS), caused by charged water drops and friction electricity of blue carrier foils, ultrasonic cleaning-induced splittering of small surface structures and EEPROM memory loss. Some examples allow valuable conclusions for failure analysis and perform hints how to reduce or eliminate the problem by tool modifications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
