Abstract
Wall pressure fluctuations have been measured in a two-dimensional separated compression ramp-induced shock wave turbulent boundary-layer interaction. The tests were made at a nominal freestream Mach number of 3 and at Reynolds numbers based on boundary-layer thickness of 7.8 X 10 and 1.4x 10. The wall temperature condition was approximately adiabatic. Large-amplitude pressure fluctuations exist throughout the interaction, particularly near separation and reattachment. In the upstream region of the flowfield, the unsteadiness of the separation shock wave structure generates an intermittent wall pressure signal. Mean wall pressures in this region result from the superposition of the relatively low-frequency, large-amplitude, shock wave-induced fluctuations on the pressure signal of the undisturbed boundary layer. This behavior is qualitatively similar to that observed in three-dimensional blunt fin-induced flows. In these two flowfields, the length scale of the shock motion is a significant fraction of the distance from the interaction start to separation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.