Universal Continuous Model of Active Power Factor Correctors

Abstract

The purpose of the work is to develop continuous mathematical models of power factor correctors for switch-mode power supplies. The models are designed to solve optimization problems aimed at increasing the energy efficiency of these devices. This goal was achieved by developing a universal continuous averaged model of switch-mode voltage converters, which are an integral part of any active power factor corrector. State-space averaging method was proposed for constructing such a universal model. It has been shown that such a model adequately reproduces the processes in any of the main types of DC-DC voltage converters. The possibility of constructing a mathematical model of an active power factor corrector based on the proposed universal model of a DC-DC voltage converter is substantiated. The features of the structures of active power factor correctors for switching power supplies are considered and the problems that arise when studying their energy efficiency are shown. By simulation in the time domain with using the constructed model, diagrams of transients of the power factor corrector during load and primary network voltage disturbances are obtained. The most important result is the creation of a universal continuous mathematical model of switching voltage regulators. This model, unlike previously proposed models, is suitable for use in the analysis, modeling and design of any power factor correctors without the need to modify it in each specific case. The significance of the results obtained lies in accelerating the design process of active power factor correctors built on the basis of any type of pulsed DC-DC voltage converters. The developed model is intended for use in the Micro-Cap electronic circuit analysis program. However, since it is ultimately a software module in the SPICE language, this model can be used in many circuit analysis programs that support this language.