Abstract

A set of four planar-chiral sila[1]ferrocenophanes equipped with a benzyl group in the α-position, either on one or both Cp rings, and substituted on the bridging silicon atom, either by methyl or phenyl groups, were prepared. While NMR, UV/Vis, and DSC measurements did not show anything uncommon, single crystal X-ray analyses revealed unexpectedly large variations of the dihedral angles between both Cp rings (α tilt angle). While DFT calculations predicted α between 19.6 and 20.8°, measured values were found between 16.6(2) and 21.45(14)°. However, experimentally determined conformers differ significantly from those calculated for the gas phase. For the sila[1]ferrocenophane with the largest mismatch between the experimental and predicted α angle, it was shown that the orientation of benzyl groups have a significant influence on the ring-tilted structure. Packing of molecules in the crystal lattice forces benzyl groups into unusual orientations, resulting in a significantly reduced α angle through steric repulsions.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.