Understanding elevated real-world NOx emissions: Heavy-duty diesel engine certification testing versus in-use vehicle testing

Abstract

For the first time, nitrogen oxide (NOx) emissions were systematically investigated during different operating conditions from a single test article on a chassis dynamometer, under real-world (on-road) conditions, on an engine dynamometer after the engine was pulled out of the vehicle, and again on a chassis dynamometer when the engine was installed back in the vehicle. The main goal of this study was to understand the discrepancies between certification and in-use NOx emission rates from a heavy-duty diesel vehicle (HDDV) with an engine with diesel particulate filter (DPF) and selective catalytic reduction (SCR) aftertreatment. The results showed that in-use NOx emissions over urban driving cycles were above the 0.2 g/bhp-hr NOx standard for most test conditions, ranging from 0.16 to 0.7 g/bhp-hr, with the highest NOx emissions for the chassis dynamometer testing. For the freeway/steady-state testing, the results were generally lower compared with the results of urban driving cycles, with values of 0.3 g/bhp-hr or less. For the Urban Dynamometer Driving Schedule (UDDS) cycle, NOx emissions were lowest for the engine dynamometer testing, followed by the on-road testing, and the chassis dynamometer testing. The differences between the tailpipe NOx emissions for the different types of tests could be attributed to differences in SCR inlet temperatures and engine-out NOx emissions.