Abstract
An austenitic Hadfield steel shows highly sustained strain hardening as well as excellent tensile strength and ductility, but its yield strength is relatively low (400 to 500 MPa). In order to overcome this shortcoming, two multi-layer steel (MLS) sheets were fabricated by the hot-roll-bonding of the Hadfield steel with two kinds of martensitic hot-press-forming (HPF) steels. Carburized and decarburized layers were formed near Hadfield/HPF interfaces by the C diffusion from the high-C Hadfield (1.2 pct) to low-C HPF (0.23 and 0.35 pct) layers. The tensile test results indicated that the two MLS sheets were fractured right after the yielding with almost no plastic deformation because the intergranular fracture appeared in the carburized and HPF layers. This intergranular fracture was caused by Cr7C3 carbide precipitation and C segregation at prior austenite grain boundaries as well as considerably high residual stresses generated in both Hadfield and HPF layers. The tempering at 473 K (200 °C) was adopted for relieving residual stresses, while most of grain-boundary carbides remained. The 473 K (200 °C)-tempered MLS sheets showed improved tensile properties over the non-tempered MLS sheets, and well satisfied a rule of mixtures.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
