Abstract
This paper investigates welding of carbon/epoxy and carbon/PEEK composites using the following procedure. Firstly, the carbon/epoxy composite was made “weldable” through a very thin PEI thermoplastic film co-cured on its surface. During the curing cycle, the PEI resin and the components of the epoxy resin system partially diffused into each other generating a gradient interphase between the original epoxy and PEI resins. Subsequently, the carbon/PEEK composite adherend was welded onto the PEI-rich surface of the weldable carbon/epoxy adherend, exploiting the total miscibility between PEI and PEEK. Thermal degradation of the carbon/epoxy adherend during the welding process was avoided via the ultra-short heating times enabled by the ultrasonic welding technology. In this research, mechanical testing was used to evaluate the weld strength relative to reference joints. Additionally, cross-section scanning electron microscopy was used to assess the morphology of the PEI/epoxy interphase before and after the welding process.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Composites Part A: Applied Science and Manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
