Abstract

In this paper, the ultrasonic spray pyrolysis (USP) technology, under normal pressure conditions was adopts in this study to deposited ZnO films. The cheap zinc acetate, ammonium fluoride, and gallium chloride was used as Zn source, F source, Ga source and Cl source, respectively for deposited F, Cl, Al and Ga co-doped ZnO (FCAGZO) films. The influence of substrate temperature (Ts) on the morphology, structure, optical and electrical properties of ZnO thin films was studied. X-ray diffraction analysis shows that the Ts does not change the crystal structure of the ZnO film, and all films have a hexagonal wurtzite structure. With increase of Ts only the preferred orientation of the film changes from (100) to (002). X-ray photoelectron spectroscopy further confirmed the successful doping of ZnO by F, Cl, Al, and Ga, which accounts for the enhancement in carrier concentration in the FCAGZO films over that of pristine ZnO. As Ts increases, the resistivity first decreases, and then gradually increases. When the optimal substrate temperature Ts = 400 °C, the prepared FCAGZO film has a resistivity of 1.47 × 10-3 Ωcm when rapid heat treatment in N2 atmosphere at 750 °C, and the average transmittance exceeds 85% in the range of 400–1400 nm.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.