Ultrasonic guided wave measurement in a wooden rod using shear transducer arrays

Abstract

Research related to acoustic/ultrasonic guided wave testing in wood is still at an early stage. This paper describes the first study to perform ultrasonic guided wave measurements in a wooden rod using arrays of shear transducers. Enhancement of either longitudinal L(0,1) or torsional T(0,1) wave modes and suppression of other modes was able to be achieved using these arrays. At low frequencies, it was found that the L(0,1) wave mode had a similar speed to that obtained using the traditional resonance and time of flight methods. The torsional T(0,1) wave mode has not been used before for non-destructive testing of wood. Since it is non-dispersive, it would appear to be suitable for wood property estimation and structural health monitoring of wooden structures. These results indicate that ultrasonic guided wave testing techniques have strong potential to be used to provide improved measurement of wood properties and structural health monitoring of wooden structures.