Abstract
In this work, a C/C composite material was nondestructively characterized and a technique was developed to measure ultrasonic velocity in C/C composites using automated data acquisition software. We have proposed a peak-delay measurement method based on the pulse overlap measurement method. Also through transmission mode was performed to compare ultrasonic velocity with the above peak-delay measurement method in an immersion tank. The variation of ultrasonic velocity was measured and found to be consistent with those in a large C/C composite. These results were compared with that obtained by dry-coupling ultrasonics. For mapping out the material property inhomogeneity, through-transmission scans were used based on both amplitude and time-of-flight of the ultrasonic pulse. A peak-delay measurement method well corresponded to the ultrasonic velocities of the pulse overlap method and through-transmission mode and C -scan image signal.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
