Abstract
Ultrasonic noise associated with various manufacturing operations has been measured in the frequency range 0–1 MHz in order to evaluate typical noise environments for ultrasonically controlled robots. Industrial operations studied include impact, bending, grinding and drilling, laser etching, and high‐velocity fluid or air sprays. The first three operations provide little ultrasonic energy above 100 kHz. For these processes, ultrasonic sensors operating above 100 kHz should have an advantage since signal and noise will both fall off with increasing frequency. Ultrasonic emission from laser etching was found to be quite broadband, making such processes less suitable for ultrasonic control. High‐velocity fluid or air sprays are the most prevalent sources of ultrasonic noise. The noise from these sources rolls off slowly with frequency, and no frequency bands without noise exist for ultrasonic sensing below several hundred kHz. For applications requiring ultrasonic sensing, aerodynamic noise should be reduced.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
