Abstract
ABSTRACTAn ultrasonic-assisted reactive brazing method, without flux and conducted in air, was developed to braze Mg/Al dissimilar alloys. By using pre-coated Zn–Al solders on the Al sheet and a short-time ultrasonic (3 s) assistance, the Mg/Al dissimilar sheets were successfully brazed at a low temperature (340°C). The effect of Al content of the solder on the shear strength was investigated based on the analysis of the microstructure and the fracture behaviour of the brazed joint. The results indicated that the microstructure and the shear strength of the ultrasonic-assisted brazed joint were significantly affected by Al content in Zn–Al solders. Increasing Al content in Zn–Al solder prevented the joint from forming the continuous brittle MgZn2 layer. The maximum shear strength of 110.5 MPa was obtained when Zn–15Al solder was used, because the joint possessed the optimum microstructure of the soft (Al, Zn) eutectoid matrix with the MgZn2 dispersed particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.