Abstract
PurposeThe development of ultrashort echo time (UTE) MRI sequences has led to improved imaging of tissues with short T2 relaxation times, such as the deep layer cartilage and meniscus. UTE combined with adiabatic T1ρ preparation (UTE-Adiab-T1ρ) is an MRI measure with low sensitivity to the magic angle effect. This study aimed to investigate the sensitivity of UTE-Adiab-T1ρ to mechanical load-induced deformations in the tibiofemoral cartilage and meniscus of human cadaveric knee joints. MethodsEight knee joints from young (42 ± 12 years at death) donors were evaluated on a 3 T scanner using the UTE-Adiab-T1ρ sequence under four sequential loading conditions: load = 0 N (Load0), load = 300 N (Load1), load = 500 N (Load2), and load = 0 N (Unload). UTE-Adiab-T1ρ was measured in the meniscus (M), femoral articular cartilage (FAC), tibial articular cartilage (TAC), articular cartilage regions uncovered by meniscus (AC-UC), and articular cartilage regions covered by meniscus (AC-MC) within region of interests (ROIs) manually selected by an experienced MR scientist. The Kruskal–Wallis test, with corrected significance level for multiple comparisons, was used to examine the UTE-Adiab-T1ρ differences between different loading conditions. ResultsUTE-Adiab-T1ρ decreased in all grouped ROIs under both Load1 and Load2 conditions (−18.7% and − 16.9% for M, −18.8% and − 12.6% for FAC, −21.4% and − 10.7% for TAC, −26.2% and − 13.9% for AC-UC, and − 16.9% and − 10.7% for AC-MC). After unloading, average UTE-Adiab-T1ρ increased across all ROIs and within a lower range compared with the average UTE-Adiab-T1ρ decreases induced by the two previous loading conditions. The loading-induced differences were statistically non-significant. ConclusionsWhile UTE-Adiab-T1ρ reduction by loading is likely an indication of tissue deformation, the increase of UTE-Adiab-T1ρ within a lower range by unloading implies partial tissue restoration. This study highlights the UTE-Adiab-T1ρ technique as an imaging marker of tissue function for detecting deformation patterns under loading.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.