Abstract
Despite the amazing properties of lightweight Mg10Li5Al alloy, its use in industrial applications is highly limited due to its low mechanical properties, wear resistance, and coefficient of thermal expansion (CTE). In this context, this work aimed to improve the above properties without sacrificing the important benefit of this alloy being lightweight. Therefore, function grade composites (FGCs) were prepared based on the Mg10Li5Al alloy reinforced by yttrium (Y) and silica fume using the powder metallurgy technique. Then, the nanocomposite's microstructure, mechanical properties, artificial aging, wear resistance, and thermal expansion were examined. The results indicated that the precipitation (MgAlLi2), softening (AlLi2), and Mg24Y5 phases were formed in high-reinforced samples during high-energy milling. Furthermore, the addition of reinforcements accelerated the decomposition from the MgAlLi2 phase to the Al-Li phase (softening point). For the layer containing the highest reinforcement content, microhardness, strength, and Young's modulus improved up to 40, 22.8, and 41%, respectively, due to the combined effect of the high strength of silica fume and the dispersion strengthening Mg24Y5 phase. Meanwhile, the same sample exhibited a remarkable improvement in wear rate and the CTE value to about 43 and 16.5%, respectively, compared to the non-reinforced alloy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
