Abstract
It is shown that chemically derived ultrafine zirconia powders (mean particle size ≤100 nm) can be processed at up to 60 vol % in a wax‐based organic vehicle by the selection of suitable dispersants and addition levels. These suspensions have been injection molded, and the resulting components sintered. This article describes the effects of two dispersants on the rheological behavior of suspensions. For the more effective dispersant, a high apparent maximum packing fraction correlates with a low yield stress, the appearance of a Newtonian plateau at low shear rate and volume fraction, and a high flow behavior index. Conversely, a less effective dispersant provides a higher yield stress, lower maximum packing fraction, and lower flow behavior index. In identical compositions of fluid, a coarse powder displays the same effects and also, when well‐stabilized, presents a dilatant transition which is ceramic volume fraction dependent. These behaviors are consistent with current interpretations of suspension rheology based on particle interactions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.