Abstract
This paper presented an ultra-high g deceleration measurement device for studies of the penetration into steel target. More than 145,000 g deceleration value was measured by this device during a penetration experiment where the steel target was 50 mm thick. Both the design of the device and the experiment of penetration into steel target were described in detail. Numerical simulation utilizing ANSYS/LS_DYNA was carried out with the same penetration condition. The numerical simulation analysis results were consistent with the experimental result. However, compared with theoretical analysis result of a previously published penetration model, the experiment one showed some disparities.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
