UiO66-NH2-TiO2/NiF photoanode for photocatalytic fuel cell by towards simultaneous treatment of antibiotic wastewater and electricity generation

Abstract

Environmental destruction, water crisis, and clean energy are among the very important challenges worldwide based on sustainable development goals. Photocatalytic fuel cell, a potential candidate for converting chemical energy into electrical energy through a pollution-free method, holds promise in addressing these challenges. In this regard, we investigated the response of a photoanode covered with UiO66-NH2-TiO2/NiF on a porous nickel foam as an attractive electrochemical response to remove antibiotics from aqueous solution and simultaneously produce electricity using a one-step hydrothermal synthesis. Nickel foam with its fine structure provides a suitable space for the interaction of light, catalyst, and efficient mass transfer of reactive molecules. It appears that it can be used as a competitive electrode in fuel cells. In order to investigate the properties of the photocatalyst, structural analyses including XRD, FESEM, FTIR, and UV–vis DRS were utilized. Additionally, polarization and electrochemical tests such as chronoamperometry and EIS were measured to further examine the electrochemical features of the PFC photoanode system. The obtained results under optimal conditions (SMZ concentration = 20 ppm, pH = 6, irradiation time = 120 min) were as follows: removal efficiency of 91.7%, Pmax = 16.98 μW/cm2, Jsc = 96.75 μA/cm2, Voc = 644 mV. The light-induced current flow in UiO66-NH2-TiO2/NiF exhibited prominent and reproducible photocurrent responses, indicating efficient and stable charge separation in TiO2/NiF composite materials, which is a promising strategy for pollutant removal and simultaneous electricity generation.