Abstract
In this study, a variety of magnetron sputtered binary and ternary thin film (approximately 1.5 µm thick) coatings using Cr, Al, and C as base elements were deposited onto Ni-201 alloy and investigated before and after exposure to simulated Type II Hot Corrosion environment. Prototypical Na2SO4 was applied to the samples before exposure for 250 hours in an air/SO2 gas mixture at 700 °C. It was determined that all coatings reduced the samples specific mass gains (corrosion rates) when compared to uncoated ones. Binary Al – C and Cr – C coatings were completely dissolved after exposure testing and NiO was the only compound detected on the surfaces; whereas continuous layers of and were detected in Cr – Al and Cr – Al – C coated samples, indicating good protection against Type II Hot Corrosion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
