Two-Phase Flow-Induced Forces on Piping in Vertical Upward Flow: Excitation Mechanisms and Correlation Models

Abstract

Momentum variation in two-phase flow generates significant low frequency forces, capable of producing unwanted and destructive vibrations in nuclear or petroleum industries. Two-phase flow-induced forces in piping were previously studied over a range of diameters from 6 mm to 70 mm in different piping element geometries, such as elbows, U-bends, and tees. Dimensionless models were then developed to estimate the rms forces and generate vibration excitation force spectra. It was found that slug flow generates the largest forces due to the large momentum variation between Taylor bubbles and slugs. The present study was conducted with a 52 mm diameter U-bend tube carrying a vertical upward flow. Two-phase flow-induced forces were measured. In addition, two-phase flow parameters, such as the local void fraction, bubble size and velocity, and slug frequency were studied to understand the relationship between the force spectra and the two-phase flow patterns. A new two-phase flow pattern map, based on existing transition models and validated using our own local void fraction measurements and force spectra, is proposed. This paper also presents a comparison of the present dimensionless forces with those of previous studies, thus covers a wide range of geometries and Weber numbers. Finally, a dimensionless spectrum is proposed to correlate forces with large momentum variations observed for certain flow patterns.